
A = Platform Width
B = Platform Depth
C = Hoistway Width
D = Hoistway Depth
E = Clear Door Width
F = Clear Door Height
O = Overhead
P = Pit Depth
R = Door Clearance
R = 5″ for Regular Type Doors
R = 6 3/4” for Pass Type Doors

Download Available Information
Contact an Elevator Package Representative to place an order
507-245-4198
Application Summary
This design utilizes two hydraulic jacks and provides maximum structural stability. The telescope jacks are located on each side of the car.
Advantages
- No jack hole s required. This eliminates the cost of drilling and the risk of oil contamination.
- Accommodates front and rear openings in any configuration.
- Available for both low and high capacity cars.
- Less overhead required than 2 stage holeless.
ENGINEERED TO ORDER – Contact MEI For Sizes or Capacities Outside Listed Ranges
Specifications
A x B
C x D
C x D
P
E x F
8′ -9 3/4“
9′ -1 1/2“
9′ -9 3/4“
10′ -1 1/2“
10′ -9 3/4“
9′ -4 1/2“
11′ -1 1/2“
12′ -9 3/4“
11′ -4 1/2“
13′ -1 1/2“
14′ -9 3/4“
13′ -4 1/2“
15′ -1 1/2“
A x B
C x D
C x D
P
WxD
WxD
E x F
4000 Lbs
4000 Lbs
5000 Lbs
5000 Lbs
6000 Lbs
6000 Lbs
8000 Lbs
8000 Lbs
10000 Lbs
10000 Lbs
Notes:
- Overhead dimensions are based on 6 foot high car gates.
- Two section car gates are not recommended for high usage installations or wide openings.
- For extra high door opening requirements, or special conditions, consult your representative.
Standard Cab Height H = 8′ -0″
Guidelines for determining overhead required:For 3 Stage Jack
- Car Speed = Up to 150 FPM
- Top Overtravel = 12″
- Bottom Overtravel = 8″
- Pit Depth = 4′ -6″
- Cab Height = 8′ -0″
Overhead Requirements:
3 Stage Jack with Single Section Gate:
Minimum of 15′ -1″ overhead required for 38′ -9″ of travel and under. Add 11/32” for every additional 1″ of travel over 38′ -8″.
3 Stage Jack with two Section Gate:
Minimum of 13′ -0″ overhead required for 32′ -0″ of travel and under. Add 11/32” to 13′ -0″ for every additional 1″ of travel over
32′ -9″.